Tungsten Carbide Chamfer Bit
Tungsten Carbide Chamfer Bit
Low stock
Sanding/Drilling bit intended for creating elevations/slopes on drilled holes
Should not be used for drilling new holes
Applicable Diameter : 1.0mm ~ 5.5mm
[Machine Translated]
- Chamfering Bit WC is a tool that can chamfer the edge of an opened hole at 45 degrees.
- The angle of the blade at the tip is 90 degrees. Compatible with holes with a diameter of 1.0 to 5.5 mm.
- Made of tungsten carbide.
- In order to prioritize the smoothness of the surface after chamfering, the specifications have many blades, so shavings are likely to get stuck between the blades .
- Please remove it frequently with a toothbrush.
- It is a hand-cranked product. We do not recommend using it with motor tools.
- Use it in addition to a pin vise, or hold it with your finger and turn it.
- After use store it in the attached case or store it so as not to damage the tip.
- It may be damaged if a strong impact is applied, such as when it is dropped onto a hard place . Please be careful.
Share
Fast shipping and always keep me updated about the delivery status
Very nice tool if you plan to drill holes or add detail parts. Leaves extremely clean chamfered edges especially for the price!
Its surprisingly easy to use and gives you very clean results. HIQParts does not disappoint!
very useful and well priced chamfering tool - for comparison the godhand bits do 1.0 to 3,0 mm holes and are about two-three times the price!
Bit shaft is about 3mm in diameter, fits in both versions of the madworks multifunction handle and a dispae tool holder but a bit too big for my Tamiya pin vice